NeuroTrac Continence is a Digital Dual Channel STIM unit suitable for:

pelvic floor muscle strengthening
urinary and faecal incontinence
bladder frequency and urgency
lack of sensitivity of pelvic floor
pelvic floor workout – combining several phases and parameters
pain relief
muscle strength and endurance

The NeuroTrac Continence has 9 built in programmes and 3 customisable, work/rest programmes which are simple to set up.

NeuroTrac Continence EMS (electrical muscle stimulation) units are widely used by physiotherapists in their practices and you can now bring the same technology to the privacy of your own home, in a simple, user-friendly compact and reliable stimulation device.

The NeuroTrac Continence records the average current used plus the time in use along with the ability to lock the unit.

What is included?

Continence electrical stimulation unit
9V Battery
2 lead wires (connects electrodes to unit)
User manual
Soft storage case

Women can use electrical stimulation with either anal, vaginal or external electrodes.

Specifications

STIMULATION

Dual channel: individually isolated circuits
Amplitude: 0 – 90 mA into 500 Ohm load; indication only. Actual mA will tend to be less than indicated due to electrode impedance: at 1000 Ohms load (Electrodes in poor condition) the maximum will be limited to 70 mA, at 1500 Ohms load the maximum will be limited to 65 mA
Type: Constant Current, maximum output voltage 180 Volts +10 / -30 Volts
Waveform: Asymmetrical, rectangular bi-phasic with zero DC current
Selectable pulse width: 50 μS – 450 μS [2% accuracy]
Pulse Rate selection: in the continuous mode 2 Hz – 100 Hz [2% accuracy]
Time duration of the treatment selectable: 1 minute to 90 minutes
Low Battery Indicator: If the battery goes below 6.9 volts +/- 0.2 volts the battery symbol will flash on/off once every second
Open Electrode Detect: If an open circuit is detected at the output of channel A or B the output current will be reset at zero
Ramp up time 0.3 – 9.9 seconds
If the battery voltage is below 6.6 (+/- 0.2) volts the unit will not turn on

Physical dimensions: 119.2 x 69 x 28.7mm

Weight: 0.07kg without battery, 0.1kg with battery.

Environmental Conditions for use:
+10 to +30 degrees Centigrade. 0-90% Humidity.

Environmental conditions for storage & transport:
10 to +50 degrees Centigrade. 0-90% Humidity.

- Dual channel: individually isolated circuits.

- Amplitude: 0 – 90 mA into 500 Ohm load; indication only. Actual mA will tend to be less than indicated due to electrode impedance: at 1000 Ohms load (Electrodes in poor condition) the maximum will be limited to 70 mA, at 1500 Ohms load the maximum will be limited to 65 mA.